Form: Design Load Combinations Selection
Click the Advanced > Frame Design > Concrete > Select Design Combo command to open the Design Load Combinations Selection form. It is not necessary to run the analysis or select an object before using the command; however, the program will not generate the code-generated automatic load combinations until at least one analysis and design iteration has been run, and therefore, the automatic load combinations will not be shown until design has been run. Use the form to review and modify the design load combinations used during design.
Load Combination Type selection box. Select the type of design combination to review or specify (i.e., Strength, Deflection).
Select Load Combinations area. All of the available design load combinations are listed in the List of Load Combinations list box. The design load combinations actually used in the design are listed in the Design Load Combinations list box. All three of the following buttons act on the highlighted design load combination in those two list boxes.
Use the Add and Remove buttons to move load combinations into and out of the Design Combos list box. Use the Ctrl and Shift keys to make multiple selections in this form for use with the Add and Remove buttons.
Use the Show button to review the definition of a design load combination.
The default concrete frame design load combinations have names such as DCON1, DCON2 and so forth.
See Also