Form: Design Load Combinations Selection
Click the Advanced > Frame Design > Steel > Select Design Combo command to open the Design Load Combinations Selection form. It is not necessary to run the analysis or select an object before using the command. Use the form to review and modify the design load combinations used during design.
List of Groups area. All of the available design groups are listed in the List of Groups list box. The design groups actually used in the design are listed in the Design Groups list box. All the following buttons act on the highlighted design group in those two list boxes.
Use the Add and Remove buttons to move load combinations into and out of the Design Combos list box. Use the Ctrl and Shift keys to make multiple selections in this form for use with the Add and Remove buttons.
The design groups are defined as part of the Bridge Object definition.
See Also