Set Load Cases to Run Form

The  Analysis  > Analyze > Run Analysis commands open the Set Load Cases to Run form. Use that form to check the analysis status of the cases, delete results for cases that have already been run, set which cases are to be run, and run the analysis or just save the settings.

The table on the form lists all defined load cases and shows the following:

Note:  To delete a load case, click the Define menu > Load Cases command to access the Define Load Cases form. Highlight the case to be deleted and click the Delete Load Case button.

Important: When you delete results, you will be asked for confirmation. After results have been deleted, they cannot be recovered except by rerunning the analysis. Clicking the Cancel button will not undelete them.

Note:  The Show Load Case Tree button also appears on the Define Load Cases form.

Note:  As the analysis is running, a Show Details button will be added to the Status bar. Clicking this button will display the results in the analysis window if they are not already displayed. Also, after an analysis has been run, the Analyze menu > Show Last Run Details command can be used to display the most recent analysis results in the analysis window. The Less/More buttons on the Analysis window can be used to decrease the size of the form, or restore it to full size, respectively.

See Also

Last Run