Verify All Connections Passed

When the Design menu >  Steel Connections Design > Verify All Connections Passed command is used, the program reports if structural members passed the stress/capacity check.

1. Click the Analyze menu > Run Analysis command to run an analysis.

2. Click the Design menu > Steel Connections Design > Start Design/Check  command to run a design.

3. Click the Design menu > Steel Connections Design > Verify All Connections Passed command.

4. ETABS will display a message indicating the outcome of the verification.

   1. If the message indicates a connection(s) did not pass, repeat Step 3 until all connections pass.

   2. Repeat Steps 1, 2 and 3 to verify the design and that all members pass.

   3. If necessary, repeat Steps 4a and 4b until all members pass.