Form: Select by Shell Label
The Select menu > Select > Labels > Shell Labels command selects objects previously specified to be shells.
Click the Select menu > Select > Labels > Shell Labels command to access the Select by Shell Label form.
Select the Story level of the shell(s) to be selected.
Highlight the name of the shell(s) to be selected in the list.
Click the Select or Deselect button. The form will remain open until the Close button is clicked, so that another selection can be made if necessary.
TIP: The Draw menu > Auto Draw Cladding command can be used to add shell objects around the outermost perimeter of the building. Those objects can then be selected using this command on a face-by-face basis (e.g., A1, A2, A3, A4) before using the Assign menu > Shell Loads > Wind Pressure Coefficient command to assign wind load.